Server Management - Systems Insight Manager
1833758 Members
3215 Online
110063 Solutions
New Discussion

Re: MSCS Cluster not recognized

 
stefano colombo_1
Super Advisor

MSCS Cluster not recognized

We have two MSCS identical clusters .
All the four nodes runs the same version of Windows 2000 Server ( SP4 ) , hotfixes, HP Management agents ( 7.10 ) , SNMP community.

We have installed HP SIM and started a discovery .
All the four nodes have been discovered but only one cluster have been discovered ( and connected to its corresponding nodes )

I tried to manually add the second cluster system but it didn't show on the main window

Anyone can give me an help ?
thanks
6 REPLIES 6
Joel Rubenstein
Honored Contributor

Re: MSCS Cluster not recognized

stefano colombo_1
Super Advisor

Re: MSCS Cluster not recognized

I tried removing the two nodes of the missing cluster,and started the discovery again but still the second cluster don't shows up
Thanks
Joel Rubenstein
Honored Contributor

Re: MSCS Cluster not recognized

Did you verify that the cluster agents were active on each of the cluster nodes?

Did you also discover the cluster IP resource?
stefano colombo_1
Super Advisor

Re: MSCS Cluster not recognized

Yes the clusters agents are enabled on both nodes and I tried to discover all three IP
Joel Rubenstein
Honored Contributor

Re: MSCS Cluster not recognized

Are the IP resources from both your clusters displayed in the "All Systems" list?

If not, then try to do a manual discovery of the missing cluster IP. Then check the "All Events" view to see if there is a "discovered systems" event for the cluster IP?
stefano colombo_1
Super Advisor

Re: MSCS Cluster not recognized

The IP resource of the missing cluster is not shown.
I tried manually adding the cluster , by providing its IP addres ,but it seems that there's a conflict with a node's IP.

I tried the following :
deleted all the nodes ( of the missing cluster ) .
- manually added node 1 , specifying SERVER and HP Proliant as info.
- manually added the cluster's IP , specifying cluster and MSCS as info.

After these steps cluster's node 1 and cluster ip resource are correctly added , and node1 is identified as cluster's member.

Then I manually added the second node .
After then the cluster IP resource disappears, the node1 still shows but as simple server and node 2 shows with the cluster's IP and as cluster ...