One blade not present

[vimeux]

Hello,
i set up HP SIM 5.1SP1, update blade integration to 3.0.
We have an enclosure (C7000) with 5 blade (1 to 5 at the top) and 3 blade (9 to 11 at the bottom).
When i use the onboard administrator interface all is fine but when i look into HPSIM the blade 9 doesen't appear : the management interface say Bay empty
Wath can i do ? thanks for your help

[breakpoint_arun]

Is blade 9 available in SIM (even if not seen in enclosure)?
can you check the system page of the blade -
under association section,
is the enclosure information available?
what is the slot value?

[deepujain]

Adding to what arun asked:
a) Is blade 9 present in HP SIM ?
b) Is blade 9 associated to its server enclosure in HP SIM? This can be viewed by going to All systems page and you should see in
c) If the answer two the above two questions is yes, then go to the system page of blad9 and check if there is a association section and expland the association section, What do you see in the slot field?
Thanks
Deepak

[vimeux]

thanks for your help,

i have no association section when i see the detail of the blade.
i discover the blade by using the manual method.
Laurent