HPE Community
Servers - General
1849823 Members
2107 Online
104044 Solutions
New Discussion

Re: UPS SNMP Management

 
L.Scott
New Member

‎03-21-2007 11:57 PM

‎03-21-2007 11:57 PM

UPS SNMP Management


I've got a R5500 XR UPS with an SNMP card - I'm trying to work out how to configure the card with an IP address so I can use the power manager to monitor it, etc.

Any ideas how to configure this?

Thanks.
0 Kudos
Reply
1 REPLY 1
Brian Vo
Trusted Contributor

‎03-26-2007 02:53 AM

‎03-26-2007 02:53 AM

Re: UPS SNMP Management

Set your Hyperterminal to 9600,8,1,N and then hotplug the card. Once serial port is connected, a service menu would be displayed. Use IP command to enter new IP address and NM for Netmask
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.