- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - Linux
- >
- Multipulse or Device Mapper Multipath?
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-25-2009 11:51 PM - last edited on 04-26-2015 09:24 PM by Maiko-I
01-25-2009 11:51 PM - last edited on 04-26-2015 09:24 PM by Maiko-I
Multipulse or Device Mapper Multipath?
Hi all,
Following is my configuration.
Hardware - BL460c Servers, Emulex LPe1105 (HP) HBAs, IBM System Storage DS8100
OS - RHEL 5 Update 2 x86_64, Oracle Enterprise Linux Update 2 x86_64
This is a new installation and we've successfully presented the san volumes from the DS8100 to Linux (RHEL and Oracle Linux).
For multipath I have two options in my mind.
1. Emulex Multipulse.
2. Device Mapper Multipath.
I've already configured both on two blades and everything works fine but it seems Multipulse is preferable because it abstracts all the redundant path devices.
Searching on IBM DS8100 site for Multipulse I was unable to find any recommendations nor oppositions for Multipulse.
Ths support site for DS8100 provides a multipath.conf file to configure Device Mapper for RHEL 5.
Are there any good reasons to stick with device mapper rather than using multipulse?
Your opinions are much appreciated.
Best regards,
Shiraj.
P.S. This thread has been moved from General to > Linux > System Administration. - Hp Forum moderator