Event ID 434

[Shafeek]

Hi Sunder,

I have also the same issue. kindly let me know if you got the solution.


Regards

Shafeek

[Daniel Leblanc]

We had to update the individual NIC drivers to 8.48, then set the team type to Automatic, transmit load balancing to Automatic.

Then on our Cisco switch...
!
interface Port-channel20
switchport
switchport access vlan 100
switchport mode access
!
!
interface GigabitEthernet6/10
description NIC1
switchport access vlan 100
switchport mode access
channel-group 20 mode active
!
interface GigabitEthernet6/11
description NIC2
switchport access vlan 100
switchport mode access
channel-group 20 mode active
!

This combination corrected the issue. If you look at the Team Properties, Statistics tab, you see that the mode negotiates to 802.3ad Dynamic with Fault Tolerance. This is what we were trying to accomplish. On previous software versions, we would set the team type to 802.3ad Dynamic with Fault Tolerance. After the driver update, this no longer worked. So half of our servers are one way, half are the other, the switch configuration for both are exactly the same as above. Hope this helps.