Server cycles when attempting to load OS

[G_33]

I have an ML370 that I have installed RC2, when I install the SSD's from SmartStart 6.10 (I have also tried 5.50 and experienced the same issue) the server begins to cycle itself when beginning to load the OS. I have an environment with identical servers and have not experienced this problem. Hardware has been checked using inspect and reported OK. Any thoughts for diagnosis?

[don_49]

Is that the G1, G2, or G3 on the ML370? Do you have a copy of 6.20 that you can try?

[Roger Faucher]

If it's a G2, here is a good resource to get everything up to the highest level before you attempt the install: http://h18004.www1.hp.com/support/files/server/us/locate/20_1341.html

Good luck!

Roger

[Roger Faucher]

Here's a link that may help you, if you're not already aware of it.

Roger

[Roger Faucher]

Here's a link that may help you, if you're not already aware of it.

http://h18001.www1.hp.com/partners/microsoft/net/support.html

Roger

[G_33]

Following the posting of my message I tried Support Disks 6.20. Unfortunately the same thing happens. I will have new code for 2003 arriving tomorrow. I will rebuild the server and test again. I will keep you posted.......