Posted to: MSA Storage
Friday I have a professional CCTV system with a DL380 Gen10 Plus server. This server is back-to-back connected to MSA2060 FC 16GB using a SN1200E 16GB HBA.This year I will replace the current server to a new DL380 Gen11 one, with is not compatible with SN12...
Posted to: HPE Morpheus VM Essentials
03-01-2025 - StoppingCan I set how the VM will behave when the host is stopped while the VM is running? Will it stop the VM, or will it be forcibly stopped without stopping the VM, etc.- StartingCan I set the VM, including the manager, to start automatically wh... Posted to: Array Setup and Networking
01-01-2021 Good DayWe currently have a Nimble CS220 which is in a boot loop and i am unable to get back online.I have removed both controllers, reseated the ram, powered off and on multiple times to no avail.This has happened in the past, however eventually boo...
Posted to: HPE Synergy
2 weeks ago Notice: HPE Synergy - Deprecating Delivery of New HPE Synergy Custom Images and Certified Vendor Add-onsI looked through this notice and I'm trying to understand the reason behind this change. In my environments with Synergy, the Certififed Vendor Ad... Posted to: ProLiant Servers (ML,DL,SL)
Friday Have a Proliant DL380 Gen10 (ILO 5) with a P408e-p controller. Trying to attach a Promise enclosure loaded with SSD's. When the array is attached I start getting temp warnings/repaired repeating from the ILO. The Promise array is well within it's ... Posted to: StoreEver Tape Storage
2 weeks ago After a scheduled power outage the MSL 6480 OCP touchscreen will not respond. The OCP will accept initial touchscreen calibration, but will not accept input after Tape Library initialization.The OCP was replaced with the replacement OCP displaying id... Posted to: Server Management - Remote Server Management
yesterday Hello, All,Good day, the MSL2024 eanable the SSL for https MGMT GUI but the SSL Cert show "Not Secure" in browser,Please help to advise how to fix,Many thanks, Posted to: ProLiant Servers (ML,DL,SL)
Thursday The FAN1 is running permanently at 100% speed, even though iLO reports values fluctuating between 20% and 25%.I have tested the fan itself by connecting it to the FAN2 header, where it behaves normally and is properly regulated. However, when any fan... Posted to: Servers - General
Thursday Greetings,I am trying to understand whether my Microserver Gen8 has a NIC firmware update available.On the Gen8 download page I downloaded a "Gen9 only" update which thankfully checked for hardware before applying. However, I found two firmware on th... Posted to: HPE OneView
Friday From the HPE Enclosure, Getting " connection to the enclosure **** could not be made. The primary OA could not be reached. Locked I am trying to remove a server from the enclosure and getting error.
