3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

clear all configuration without wipe

 
Highlighted
BlackRoze
Occasional Advisor

clear all configuration without wipe

hi all

i want to clear all configuration HPE 3par 8440 and i need clear all alarm and delet all data dsik suck as the picture

 

1.jpg2.jpg3.jpg

 

 can i used these commadn to clear all configuration ?

"removevlun -f -pat *

removevv -f -pat *

 

this comand form mr   Sheldon Smith

 
 

 

 

i need clear all the alarm  other than pwoer failuerd  i need the the all command need the clear all configuration without wipe that need console password

 

best regards

Ali

1 REPLY 1
Highlighted

Re: clear all configuration without wipe

There is no magic "reset" command. You will need to go through the 3PAR Command Line Reference manual. All the commands are "remove" commands. Go through them in the order I listed below. Note the removevlun and removevv commands have a "-dr" (dry run) option so you can see what they would remove before actually removing the opbjects.

removevlun
removevvset
removevv
removehostset
removehost
removealert

As virtual volumes and the underlying logical disks are deleted, the chunklets will go to the uninitialized queue where they will be cleaned for future use. To check on the status of the physical disks and their chunklets, see the
showpd -c
command.


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo