HP 2530 J9772A Voice VLAN

[ag11]

Good morning!

So have two VLANs configured on my switch, the default VLAN for data, and a VLAN2 for voice.  I was troubleshooting the VLAN with a laptop and if I tag a port for VLAN 2, I can get network/internet connectivity on the laptop as long as I enable VLAN and set VLAN 2 on the laptop NIC. If I try to put in a Cisco VoIP (SPA501G) on that port, I don't get any connectivity. Going through the configs, the phone pulls the proper VLAN2 network configurations using IP-Helper, but not VLAN information. I've tried enabling CDP but no luck. Any thoughts would be greatly appreciated.

[ag11]

Nevermind, problem solved!

[ElsM]

How ?

[cbka]

Hi, try this:

qos dscp-map 101110 priority 6
qos type-of-service diff-services

vlan 1
   name "DEFAULT_VLAN"
   untagged 1-48,A1-A2,B1-B2
   exit
vlan 100
   name "VOICE"
   tagged 1-48
   qos dscp 101110
   voice
   exit

Also enable lldp-med run

perhaps this helps you ...

http://www.snackarelli.com/2014/01/procurve-voip-lldp-med-and-qos.html

[cbka]

Why don't you mark your thread as solved and provide a solution ? So you can contribute sth to the forum instead of just asking stuff ?

Cheers, Chris

[Norna]

Hi all,

I have hp 2530 that I want to configure it to use IP phone and Wifi ,its currently a flat switch.

Please help, I not clued up HP's

[cbka]

Hi norma,

Can you please provide a little more Info pls?