- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- HP Switch 5406zl (J8697A) Serial connection
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2019 03:43 AM
03-13-2019 03:43 AM
HP Switch 5406zl (J8697A) Serial connection
Hi there,
I've a situation with HP Switch 5406zl (J8697A) switch.
It turns out that is working fine but I lost its IP access due to a bad action, so I've no access through http/telnet.
"Easy, serial cable and Putty" you must think, but no. I'm struggleling with this.
I've review official PDF documentation to find out console parameters, they are standard.
I've used those parameters in Putty but I've no answer from switch, the whole thing seems quite simple.
I'm using RS232 DB9 female <-> DB9 female, but there's no response from the switch using Putty application, is that the right cable?
I was thinking also to reset it to factory deffaults, but I will need to configure it afterward using serial cable, so right now is not a good idea.
I've tried using also rj45 - rs232 with same results.
Any idea? any help will be appreciated.
Thanks