Aruba & ProVision-based
cancel
Showing results for 
Search instead for 
Did you mean: 

Module not present for port or invalid port - only for one specific port

 
SOLVED
Go to solution

Module not present for port or invalid port - only for one specific port

Hi,

 

I'm having some trouble with one specific port in my zl5406 switch.

The ports is at my desk, i use it for configuring access-points and so on.

 

Everytime i try to move the port into another VLAN i get this error:

"Module not present for port or invalid port: a14"

 

As i said, its only for this port, and it is up, and working, sending out PoE to my access-point.

 

Any ideas?

 

 

 

5 REPLIES 5
Mohammed Faiz
Honored Contributor

Re: Module not present for port or invalid port - only for one specific port

What does the output of a "show mod" give you?

Chrisd131313
Trusted Contributor
Solution

Re: Module not present for port or invalid port - only for one specific port

The port isnt configured as a trunk is it?

-----------------------------------------------------

Don't forget to mark a post resolved if your question was answered.

Re: Module not present for port or invalid port - only for one specific port

It seems i was in a trunk, and now that i think of it, i used it for some trunking tests before the summer - totally fogot!

 

Thank you for your answers, it is much appriciated!

 

/Mick

Chrisd131313
Trusted Contributor

Re: Module not present for port or invalid port - only for one specific port

No problem Mick, I have done that enough times and wondered why the switch doesn't see the individual port ;)

 

All the best

-----------------------------------------------------

Don't forget to mark a post resolved if your question was answered.
DCA-RichM
Occasional Advisor

Re: Module not present for port or invalid port - only for one specific port

I have this same error when attempting to use the show interface trunk-utilization command as recommended by HP in the release notes for the KB.16.02.0013 firmware. KB.16.02.0013 release notes.

I have three trunks configured on the switch but am getting this message when attempting to look at a specific trunk's utilisation. Do you know why I would be getting this message in this instance?

Thanks