Procurve Manager - How to light the "Locator" lamp ?

[Jim Helfer]

I am running the current version of Procureve Manager configuring two indentical 2810-48G switches.

I would like to light the indicator lamp on one of them, just to avoid confusion, but I can't find anyway to do it on any of the screens.
How is this done?

Thanks

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

[Sietze Reitsma]

Hello,

I have access to a 3500, but I think it's the same command.

3500(config)# chassislocate blink

or

3500(config)# chassislocate off

or

3500(config)# chassislocate on

The led will be on for 30 minutes by default.

[Jim Helfer]

Thanks, but I don'tknow how to enter those commands. Is there some way I can do this from the Procurve management software?

[Richard Brodie_1]

If you have Telnet enabled on the switch you can open a Telnet session from the device access menu.