Temperature Blinking LED

[AAPP Toledo]

Hi,

I've several problems with the temperature of one switch (5406zl), always is Over Temp and it's impossible to find a solution (you know.. no-ventilation, no-AirConditioner, etc.).

In conclusion... The Temp LED on Management Module is always blinking and I need to found a command to deactivate the Temp Led, change the temperature parameters or that the Switch doesn't check the temperature.

Any idea?

Many thanks in advance and greetings from Spain.

[Patrick R]

If you run the show system temp and you are also getting 9999 value, then you should get in contact with the support. Mostly after updating the FM 

[AAPP Toledo]

Hi Patrick,

Firstly, thanks for answer. If I run sh system temperature I get the following values: 

AAPP-Planta3# sh system temperature
 System Air Temperature
     #      Current Temp Max Temp   Min Temp   Threshold   Over Temp
   -------- ------------ ---------- ---------- ----------- ----------
  + Sys-1    41C          44C        40C        40C         YES      

Yeap.. .The heat is on but the Blinking Led and the Log Alarm appear later to update the version from K.14.60 to K.15.04.0007 (It's a 5406zl). And the temperature is true, because measuring it with a real thermometer and gave me 4 degrees less.

Greetings...