HPE Community
Aruba & ProVision-based
1756000 Members
2904 Online
108839 Solutions
New Discussion

Utilzation on HP 2910Switch

 
SOLVED
Go to solution
jwc1972
Advisor

‎10-05-2011 01:52 AM

‎10-05-2011 01:52 AM

Utilzation on HP 2910Switch

Hello

We have never had a managed swicthed before. What is accepteable for Utlization? We have two ports on about 15-20%

on Uncast TX % all TX is that correct

 

Regards

0 Kudos
1 REPLY 1
showneek
Respected Contributor

‎10-06-2011 09:19 AM

‎10-06-2011 09:19 AM

Solution

Re: Utilzation on HP 2910Switch

Hi,

 

no worry about it. It is low utilization at all. The critical threshold usually begin let's say at round 80 % and there you should do some investigation what is happening. 100% utilization usually means to much traffic that switch cannot handle (traffic congestion, loop in network, etc.).

 

BR,

Jan

The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.