- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Change from Factory WWNs to HP VC WWNs
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
The article you are trying to access is permanently deleted.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО03-07-2008 04:19 PM
тАО03-07-2008 04:19 PM
I assumed that once these modules were added, I could complete the FC Setup Wizard (since it previously was just Ethernet) and it would give me that choice to choose which I wanted to use.
Any help would be appreciated.
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО03-08-2008 12:43 AM
тАО03-08-2008 12:43 AM
SolutionYou can't change from factory->HP def if there is profiles with FC allready defined. Then You must unassign the profile before it's possible to change the WWN setting
You can find me from Twitter @JKytsi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО03-08-2008 05:20 AM
тАО03-08-2008 05:20 AM
Re: Change from Factory WWNs to HP VC WWNs
I assumed (incorrectly) that when we added the new VC FC Modules, we would be able to complete the Fiber Channel Setup and select HP Predefined WWNs.
I'm now curious, could I have done the FC Wizard even though I didn't have any FC Modules installed from the beginning, simply to tell the chassis that "If" we do add modules in the future we would use Virtual WWNs.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО03-08-2008 10:57 AM
тАО03-08-2008 10:57 AM
Re: Change from Factory WWNs to HP VC WWNs
But did You try to run it ? It does not matter if You have defined the profiles with HP def MAC addresses, You should be able to complete FC wizard with HP def values. Only if You would have defined profiles with factory WWNs the unassign would be necessary.
You can find me from Twitter @JKytsi