HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
Showing results for 
Search instead for 
Did you mean: 

Monitoring blades with SNMP via OA

Occasional Visitor

Monitoring blades with SNMP via OA

Hi Everyone


I'm trying to set up SNMP monitoring on HP C7000 Enclosure. I'd like it to send traps to HP SIM server for all the components in the enclosure. I configured everything in Enclosure settings->SNMP settings and I'm able to receive traps for e.g. OA reset events; however I don't get anything from blades. When I reset a blade I get an event in the OA log but nothing goes to HP SIM. I don't want to set SNMP monitoring in the iLO. My question is - is this behavior by design or should I configure anything else in the HP SIM or OA?


Best regards


Valued Contributor

Re: Monitoring blades with SNMP via OA



if you wan't to get the events of the blades also, you have to configure the SNMP in the iLOs or in the OS of the blades!

The SNMP configuration in the OnboardAdmin is only for the events of the OA.