BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

After upgrade to 3.60 VC domain cannot finish synchronization

 
vmwaremine
Occasional Visitor

After upgrade to 3.60 VC domain cannot finish synchronization

Hi all

 

I did upgrade of VC to version 3.6 on C7000 and after upgrade VC domain synchronizing forever, see printscreen,

 

OA - 3.71

VC - 3.60

What I did:

  • reset both VC
  • power of and power up both VC
  • reset VCM

Enclosure details:

C7000 - single enclosure

VC Flex 10 - two modules

HP 4Gb VC_FC module - 2 modules

HP 1/10 VC-Enet module

 

At the moment VC is not operational, sometimes even log in is not possible.

Any advice ?

 

Thanks

Artur

www.vmwaremine.com

6 REPLIES
hanky_q
Occasional Visitor

Re: After upgrade to 3.60 VC domain cannot finish synchronization

Can you connect to the secondary VC Module?

vmwaremine
Occasional Visitor

Re: After upgrade to 3.60 VC domain cannot finish synchronization

yes, I can connect to secondary module but situation is the same

 

 

Artur

www.vmwaremine.com

hanky_q
Occasional Visitor

Re: After upgrade to 3.60 VC domain cannot finish synchronization

Have you reboot the seconday Module? Maybe that device could not load the configuration
vmwaremine
Occasional Visitor

Re: After upgrade to 3.60 VC domain cannot finish synchronization

Yes, I did reboot and power off both devices + 1/10 ENET module

 

Artur

www.vmwaremine.com

hanky_q
Occasional Visitor

Re: After upgrade to 3.60 VC domain cannot finish synchronization

What happen if you disconect the seconday VC from the network? 

Maybe both modules are trying to get primary. 

 

And are both with the same Version?

Jongo
Occasional Visitor

Re: After upgrade to 3.60 VC domain cannot finish synchronization

Maybe if you have a Virtual IP address to access VC has got out of sync.

 

Disable it and re-enable via an ssh session to one of he bays