BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Factory-default WWN

LARRY FUTCH
Occasional Contributor

Factory-default WWN

I'm trying to move some blades from an enclosure using the VC-assigned FC WWN's to a different enclosure that is set to use the factory-default ones.  I'd like to be able to pre-provision my zone changes and host ports in the array, but I haven't been able to find out what the factory-default WWN's are.

 

Every place I look shows only the VC assigned ones.

 

Is there a way to see the factory-default WWN's without shutting down the server?

 

Thanks in advance for any suggestions.

1 REPLY
rkjha_hp
Advisor

Re: Factory-default WWN

If you will check the system information using Onboard Administrator it will show the factory coded WWN.

 

If you are going to connect blade server in a chassis which dont have VC configured or set to Factory WWN, system information in OA will show factory WWN.