BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Help with stacking

Beso
Occasional Contributor

Help with stacking

Hi

I have one encolusre with 2 HP VC FlexFabric 10Gb/24-Port Module 

port x1,x2,x3 are for fiber channel , connect with storage, port x4 are free,

port x5-x6 are for server network, configured as active/standby, port x7 are for dmz network, x8 are for internal stackings

 

but now, i need add 2 new HP VC FlexFabric 10Gb/24-Port Module,

  i have some questions:

*add this new 2 module in interconnect bay 3 and 4, of in bay 5 and 6, is diferent betveen 3-4 and 5-6 paar?

*can i stack x4 port between bay 1 and 3, and 2 and 4 ? 

*need physically stack ports x8 ?

 

thanks for ansvers and sory for my bad english )

 

2 REPLIES
scharchouf
Trusted Contributor

Re: Help with stacking

you can see the "Installation Guide", there is the answer to all your questions. Setup and Installation Guide

 

I work for HP
A quick resolution to technical issues for your HP Enterprise products is just a click away HP Support Center Knowledge-base
See Self Help Post for more details

raf2
Frequent Advisor

Re: Help with stacking

You need to move some stuff to the new modules. Do not use both X7 and X8 for stacking or otherwise. With all those new ports you should free up X7 and X8 and stack between your new FF and old FF modules with X6 or another free port. X7 and X8 act as internal failover stacking links between partner modules (bay 1 and bay 2 for example).