2928 Baseline - Disable Spanning Tree

[jfoss]

Hi

I have a 2928 switch and need to disable spanning tree permanently so that it holds thru restarts and power outages.Currently I can disable it, but if the unit restarts it reenables STP automatically. The unit that this replaces, the 2924-sfp had a "Write Changes" button that allowed this, but the new unit does not have this. The CLI instructions do not cover this.

Anyone know how to do this?

Thanks

[jfoss]

I finally found it. The interface is completely different than the 2924. The 2924 was a large button at the top of the left hand column. In the 2928 you must go to Device/Configuration and once there click on "Save".

It holds.

Thanks.