Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

IRF Add new Member and how to replace a fault switch

FrankM23
Occasional Contributor

IRF Add new Member and how to replace a fault switch

Hi,

 

1. IRF Add new Member

 

we want to expand our current IRF Stack with a new member 5

 

                              Topology Info
 -------------------------------------------------------------------------
               IRF-Port1                IRF-Port2
 MemberID    Link       neighbor      Link       neighbor    Belong To
 1           UP         4             UP         2           cc3e-5f97-9798
 4           UP         3             UP         1           cc3e-5f97-9798
 3           UP         2             UP         4           cc3e-5f97-9798
 2           UP         1             UP         3           cc3e-5f97-9798

 

The new member has a different firmeware-version as the switches in the IRF stack, could that be a problem? What is the procedure to add a new member in a existing IRF Topolgy?

 

 

2. replace a fault switch

 

What steps are required to replace a faulty switch?

 

 

Thank you!

2 REPLIES
VoIP-Buddy
HPE Pro

Re: IRF Add new Member and how to replace a fault switch

IRF members must all be part of the same switch family and run the same version of software.  Otherwise, they will not be able to be added to the IRF.

 

David

Richard Litchfield
Respected Contributor

Re: IRF Add new Member and how to replace a fault switch

Replacement process for IRF switch included in the attached doc.