Storage Boards Cleanup
To make it easier to find information about HPE Storage products and solutions, we are doing spring cleaning. This includes consolidation of some older boards, and a simpler structure that more accurately reflects how people use HPE Storage.
Disk Arrays
cancel
Showing results for 
Search instead for 
Did you mean: 

Raid array lost one service processor

James F. Kent
Occasional Visitor

Raid array lost one service processor

When I get my SP replaced how do I get back the original configuration. It doesn't show up in ioscan -fnkC disk any longer. What is the order I should do?
vgcfgrestore vgscan -a or what?
Perfection is bliss
3 REPLIES
Gerrit Beyken
Respected Contributor

Re: Raid array lost one service processor

Hi,

do a full and refreshing scan instead of reading from Kernel by "ioscan -fnC disk" (without the "k" option).
Now your disks (which i think are the alternate paths) must show up.
Now you can do a "vgdisplay -v " and see if your config is ok.

Best regards

Gerrit Beyken

Re: Raid array lost one service processor

I assume you are replacing the SP due to a failure? If so, provided nothing has changed on the array, simply do ioscan to force the system to reread the io paths.
My house is the bank's, my money the wife's, But my opinions belong to me, not HP!
David Bell_1
Honored Contributor

Re: Raid array lost one service processor

James,

If this is an FC array, it may be necessary to run fcmsutil replace_dsk routine to tell the array you know the SP was replaced. You will need the N-Port ID for this. You can obtain this with a tdlist command. The typical symptom of this is a NO_HW under ioscan. Follow the suggestions mentioned first ioscan -fnCdisk (without 'k'). If that shows NO_HW, do a man on fcmsutil.

HTH,

Dave