Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Brocade Sikworm 2800

SOLVED
Go to solution
SOSS Support
Occasional Visitor

Brocade Sikworm 2800

I am looking any standard and/or recommendation on
how to setup a Brocade Silkworm 2800 fiber switch for
full fabric O.S. support. I have read the manual and
found that there a lot a parameters to setup, are
they all supported as there are no SAN standards as of
yet. Any recommendation would be appreciated.
2 REPLIES
Mark van Silfhout
Trusted Contributor
Solution

Re: Brocade Sikworm 2800

Hello,

The Brocade 2800 is by default configured for full fabric. But firmware revision 2.1.9f is highly recommended.
Also be sure that if you have A5158A FC cards, you need the B.11.00.05 version of the Tachyon driver.

Regards,

Mark
JD_3
Occasional Visitor

Re: Brocade Sikworm 2800

..actually for your configuration we will need to have more info...Lun Masking, zoning....
Full switched fabric...
JD