HPE Community
Disk Enclosures
1756951 Members
2396 Online
108857 Solutions
New Discussion

Re: FC60 controller in Passive mode

 
Nelson Broskey_2
New Member

‎01-05-2000 01:22 PM

‎01-05-2000 01:22 PM

FC60 controller in Passive mode

In case anyone has reconfigured or otherwise confused their FC60 array (A5277A
Surestore E Disk Array) such that one or both of its controllers have gone
"passive" there is an undocumented (at least so far) command to reset them to
"active" state. It is:

ammgr -c AA
0 Kudos
Reply
1 REPLY 1
Nelson Broskey_2
New Member

‎01-05-2000 01:33 PM

‎01-05-2000 01:33 PM

Re: FC60 controller in Passive mode

OOPS!
That command needs the array id after it as usual. not sure why "arrayid"
surrounded by arrows as used in the users guide did not post on the first
message...let me use parenthesis instead:

ammgr -c AA (arrayid)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.