- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Where to get details about logprint output from 12...
-
- Forums
-
Blogs
- Alliances
- Around the Storage Block
- Behind the scenes @ Labs
- HPE Careers
- HPE Storage Tech Insiders
- Infrastructure Insights
- Inspiring Progress
- Internet of Things (IoT)
- My Learning Certification
- OEM Solutions
- Servers: The Right Compute
- Shifting to Software-Defined
- Telecom IQ
- Transforming IT
- Infrastructure Solutions German
- L’Avenir de l’IT
- IT e Trasformazione Digitale
- Enterprise Topics
- ИТ для нового стиля бизнеса
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
07-23-2003 05:36 AM
07-23-2003 05:36 AM
Where to get details about logprint output from 12H
Does "Disk drive removed" mean physically removed, or just removed from service due to excessive errors?
Does "Rebuild started" always report from slot A1, or is there other significance?
How serious is "Disk Drive Data Out Of Sync After Access?" I've attached the output from an array where theres was an initial failure (B6), the disk was replaced (by the end-user), and we've had subsequent failures of B6 and B1. It looks like the end user had some trial and error attempts at replacing the failed disk. But what I'm really looking for is more detail on the logprint output.
I'm attaching a trimmed down capture of the particular logprint.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
07-23-2003 06:57 AM
07-23-2003 06:57 AM
Re: Where to get details about logprint output from 12H
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
07-23-2003 07:08 AM
07-23-2003 07:08 AM
Re: Where to get details about logprint output from 12H
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
07-23-2003 07:58 AM
07-23-2003 07:58 AM
Re: Where to get details about logprint output from 12H
- Redundancy Loss
- Active Hot Spare Unavailable
- Rebuild Failed
- Missing Disk
Firmware is up-to-date, although ARM software is not
My recommendations: shutdown 12h, then power it off, then reseat all components (disks) - reseat means pull and push them back securely. Turn 12h on and look at 'arraydsp -a' and front panel again. You need to return missing disk into the set...
Eugeny
Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2019 Hewlett Packard Enterprise Development LP