HPE Community
Operating System - HP-UX
1757725 Members
2300 Online
108863 Solutions
New Discussion юеВ

Startup HP-UX 10.20 display blank during start-up

 
mike_teoh
Occasional Contributor

тАО10-24-2004 04:00 PM

тАО10-24-2004 04:00 PM

Startup HP-UX 10.20 display blank during start-up

Startup HP-UX 10.20 display blank during start-up. The display go into display prompting and unable to go to console login display.
If I use to control break the thing, the thing go to term display mode.
Wonder how to set to make my hp-ux 10.20 terminal automatically to go console login display mode under stand alone mode without networking.
Appreciate someone can help up. Thank in advance.
0 Kudos
Reply
3 REPLIES 3
T G Manikandan
Honored Contributor

тАО10-24-2004 04:47 PM

тАО10-24-2004 04:47 PM

Re: Startup HP-UX 10.20 display blank during start-up

can you please explain.I could not understand your Q.

are u taking about CDE not working,its just blank!
0 Kudos
Reply
mike_teoh
Occasional Contributor

тАО10-24-2004 04:51 PM

тАО10-24-2004 04:51 PM

Re: Startup HP-UX 10.20 display blank during start-up

My CDE still to be not working
0 Kudos
Reply
T G Manikandan
Honored Contributor

тАО10-24-2004 05:22 PM

тАО10-24-2004 05:22 PM

Re: Startup HP-UX 10.20 display blank during start-up

Run

#/usr/contrib/bin/X11/dr_dt >/tmp/cdedebug

then check /tmp/cdedebug and revert


0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.