HPE Community
Operating System - Linux
1754053 Members
2783 Online
108811 Solutions
New Discussion

cpqhealth & Smart Array error notification

 
Jay McCanta
New Member

‎05-01-2003 10:22 AM

‎05-01-2003 10:22 AM

cpqhealth & Smart Array error notification

I am running RH 8.0 on a DL380/G2 and have installed the Proliant Support Pack. The modules load and processes start. I don't have an Insight Manager stations. I would like to configure the system to log errors a log file. Right now, if I remove a disk from the RAID set, I see no messages anywhere.
0 Kudos
Reply
1 REPLY 1
david_69
Advisor

‎05-02-2003 05:42 AM

‎05-02-2003 05:42 AM

Re: cpqhealth & Smart Array error notification

Check Dmesg, also check to make sure kern.all is going somewhere in your /etc/syslog.conf
fall down seven time stand up eight
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.