- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- HPE 9000 and HPE e3000 Servers
- >
- Re: A class refuses to boot
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-03-2006 02:59 AM
тАО11-03-2006 02:59 AM
A class refuses to boot
Main Menu: Enter Command > bo
ERROR: the stop boot flag is set - can't leave the user interface to attempt to boot. Boot terminated
i have never seen this error message before, can anyone shed any light on this
Cheers
John
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-03-2006 04:01 AM
тАО11-03-2006 04:01 AM
Re: A class refuses to boot
Can you reset the server and try to boot it from CD or tape then capture all error message from the console. Maybe you can find something useful.
Yang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-03-2006 08:29 AM
тАО11-03-2006 08:29 AM
Re: A class refuses to boot
go into th info menu at BCH and type wa for warning.
see if there was a warning when it booted? possibly a memory error similar is stopping it from booting.
Andy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-05-2006 12:17 PM
тАО11-05-2006 12:17 PM
Re: A class refuses to boot
Possible reasons for "stop boot flag"-
do not have minimum amount of good memory,
access port/Serial interface is present but has failed selftest
default stable storage failed & cannot init eeprom,
EISA subsystem failed - (EISA Controller) failed or is not detected,
PDT is disabled and has entries. Given this, there is deallocated(BAD)
memory which could get used.
Best Regards,
Prashanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО11-08-2006 08:49 AM
тАО11-08-2006 08:49 AM