HPE Community
HPE EVA Storage
1754223 Members
3599 Online
108812 Solutions
New Discussion

eva6400 scsi error

 
Daniel Kujawa
Occasional Contributor

‎04-20-2010 05:53 AM - last edited on ‎03-11-2015 07:43 PM by

‎04-20-2010 05:53 AM - last edited on ‎03-11-2015 07:43 PM by

eva6400 scsi error

Hello,

Our 6400 keeps returning the following scsi busy messages to 2 servers that are connected to it:


kernel: sd 1:0:4:2: SCSI error: return code = 0x00020000
kernel: end_request: I/O error, dev sdjv, sector 195796992
kernel: device-mapper: multipath: Failing path 65:400.
multipathd: dm-44: add map (uevent)
multipathd: dm-44: devmap already registered
multipathd: 65:400: mark as failed
multipathd: malsto05_ldtoradata2: remaining active paths: 7
multipathd: sdjv: tur checker reports path is up
multipathd: 65:400: reinstated
multipathd: malsto05_ldtoradata2: remaining active paths: 8
multipathd: dm-44: add map (uevent)
multipathd: dm-44: devmap already registered


the eva doesn't show anything in the CV EVA logs. I've upgraded to the latest RHEL5 multipath software but no difference.

Any ideas or suggestions ?

Thanks

 

 

P.S. This thread has been moevd from Disk, Disk Arrays (Retired Discussion Board) to Storage Area Networks (SAN) (Enterprise). - Hp Forum Moderator

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.