Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
cancel
Showing results for 
Search instead for 
Did you mean: 

ICLE question

ICLE question

After my target blade BL460C is identified by ICLE 2.0 / SIM with the correct operating system (server is adm_msgdevpri). After I reboot the server the Product name changes to linux server.
(see attached document)
Any ideas.
1 REPLY
Christopher Grandinetti
Frequent Advisor

Re: ICLE question

Hi Mario,

The development team believes this is due to snmp not being configured (turned on) on the management node.

Please run the snmpwalk utility on the CMS against the managed node to verify that snmp is properly configured:

# snmpwalk -Os -c -v 1 if

If the snmpwalk doesn't work, you can run "Configure and Repair agents" to fix this; providing the agents are properly installed.

Regards,
-Chris