HPE Community
Integrity Servers
1756989 Members
2215 Online
108858 Solutions
New Discussion юеВ

vpar on blade

 
Mauro Facchetti
New Member

тАО10-08-2010 03:57 AM

тАО10-08-2010 03:57 AM

vpar on blade

Hi,
Is it possible to create vpars in BL860C i2 blade?
Thanks,
Srini
0 Kudos
Reply
3 REPLIES 3
Michal Kapalka (mikap)
Honored Contributor

тАО10-08-2010 05:28 AM

тАО10-08-2010 05:28 AM

Re: vpar on blade

hi,

check this answer :

http://forums13.itrc.hp.com/service/forums/questionanswer.do?admit=109447627+1286544401184+28353475&threadId=1443997

mikap
0 Kudos
Reply
Torsten.
Acclaimed Contributor

тАО10-08-2010 12:36 PM

тАО10-08-2010 12:36 PM

Re: vpar on blade

AFAIK the answer is still the same at this time (for all the BL8x0c i2's) - no.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
melvyn burnard
Honored Contributor

тАО10-09-2010 11:36 AM

тАО10-09-2010 11:36 AM

Re: vpar on blade

There are no current plans for the implementation of vPars any of the BL8xxCi2 blades
My house is the bank's, my money the wife's, But my opinions belong to me, not HP!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.