HPE Community
Operating System - HP-UX
1752772 Members
4854 Online
108789 Solutions
New Discussion юеВ

Re: adding disk to vg01

 
Raj_00723
Occasional Contributor

тАО09-25-2008 05:28 AM - last edited on тАО03-30-2014 08:07 PM by

тАО09-25-2008 05:28 AM - last edited on тАО03-30-2014 08:07 PM by

adding disk to vg01

Need to add two disk in vol grp. vg01. Please guide.

Server model is N4000
OS HPUX 11.11

 

 

P.S. This thread has been moevd from Disk to HP-UX > LVM and VxVM. - HP Forum Moderator

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО09-25-2008 06:40 AM

тАО09-25-2008 06:40 AM

Re: adding disk to vg01

Are these 2 disks or only a single disk with 2 pathes?

Anyway, run

# insf -e

to install the device files, create a physical volume

# pvcreate

and extend the vg

# vgextend vg01

Make sure all the VG settings are high enough for the new disks.

If needed, post "ioscan -fnCdisk" again after "insf" was running together with "vgdisplay -v vg01".

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Raj_00723
Occasional Contributor

тАО09-25-2008 08:02 AM

тАО09-25-2008 08:02 AM

Re: adding disk to vg01

Thanks,

Have added the disk.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.