HPE Community
Operating System - OpenVMS
1754051 Members
3438 Online
108811 Solutions
New Discussion

Re: DECNIS 500 Hang

 
Mario Abruzzi
Contributor

‎02-28-2005 05:41 PM

‎02-28-2005 05:41 PM

DECNIS 500 Hang

I have a DECNIS 500 that is used exclusively for X.25 communications. I recently started experiencing trouble with this DECNIS that is characterized by my inability to SHOW and attribute using NCL (the connection ultimately times out). Moreover, I am not able to successfully perform a CTF trace of Level 2 or Level 3.

So far, Field Service has replaced every component except for the memory module, which happens to be the most likely cause of this problem.

Has anyone else experienced these same symptoms? If so, could you describe the resolution, if any?
0 Kudos
Reply
1 REPLY 1
Ian Miller.
Honored Contributor

‎02-28-2005 07:43 PM

‎02-28-2005 07:43 PM

Re: DECNIS 500 Hang

Its been a while since I saw one but it does sounds like lack of memory and thefore replace the memory.
____________________
Purely Personal Opinion
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.