HPE Community
ProLiant Servers (ML,DL,SL)
1827415 Members
5094 Online
109965 Solutions
New Discussion

Re: 1783 - Slot 0 Array controller is in a lock up State

 
karrar1065
Occasional Visitor

‎05-29-2017 04:24 AM

‎05-29-2017 04:24 AM

1783 - Slot 0 Array controller is in a lock up State

Following is the screen shot of the error when server starts. 

 

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎05-29-2017 05:00 AM

‎05-29-2017 05:00 AM

Re: 1783 - Slot 0 Array controller is in a lock up State

Looks like an old system ...

Consider to remove the cable to the disks and check if the error remains.

Disconnect the cache module, if possible and present.

If the issue remains, the controller is likely defective. Depending on the hardware it is integrated into the system board or a single module.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
PZel
Trusted Contributor

‎05-30-2017 04:36 AM

‎05-30-2017 04:36 AM

Re: 1783 - Slot 0 Array controller is in a lock up State

Probably its the BBWC. Replace it by a new 413486-001 (128MB cache module) for the DL380G4

PZ
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.