DL580 Memory Board Problem

[Bill_287]

I just reallocated a used DL580 G2 to my service. When powering the system up I got no video and after about 30 seconds I get a series of long beeps. All the lights on memory board 2 were flashing orange. Through some troubleshooting I've been able to get it to boot with memory board 1 inserted and populated with 16G of RAM. When I install memory board 2 with or without RAM the system won't POST, no video, and long single beep again, plus it then flashes all the lights on memory board 1 orange. Remove the empty or full memory board 2 and the system will boot just fine no errors. I have several new memory boards that I will be trying but wanted to see if anyone has any ideas.

Thanks

Bill

Also, I've done disaster recovery mode, erased NVRAM and have updated all to the latest firmware.

[Raj_75]

Hi Bill,

It's most likely that your server memory board 2 is faulty.