HPE Community
ProLiant Servers (ML,DL,SL)
1757437 Members
2496 Online
108861 Solutions
New Discussion юеВ

F1 to continue

 
Ayman Altounji
Valued Contributor

тАО03-18-2001 04:00 PM

тАО03-18-2001 04:00 PM

F1 to continue

How do get rid of the Hit F1 to continue at boot? I have seen this on other Compaq servers and found it in the setup, but I can't find it on this ML530. Your replies are appreciated.
Paul
0 Kudos
Reply
2 REPLIES 2
Ayman Altounji
Valued Contributor

тАО03-28-2001 04:00 PM

тАО03-28-2001 04:00 PM

Re: F1 to continue

I have also installed several 530s with NT40 (Select) - I do not know if this make any change - and it is quite annoying that upon reboot it waits inifnitly to press f1 or f10. Is there a workaround for this?
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО05-23-2001 04:00 PM

тАО05-23-2001 04:00 PM

Re: F1 to continue

When booting, go into system partition utils and hit ctrl-A for advanced mode, somewhere in there you will find an option for F1 prompt. If not, then you might need to update the bios.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.