ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant 800- Deleted Sys partition-Still

 
SOLVED
Go to solution
Tudor Moore
Occasional Contributor

Proliant 800- Deleted Sys partition-Still

Sorry, Thought I had this one sorted.
I have used maintance switch to clear NVRAM but after going thru POST and RAID Setup I still get the F1/F10 Prompt. F10 being partition utils which isn't there. If I go thru the F1-continue, then I get Default Sys Config Install-Run System Conf to View/Mod Settings then a list of O/S's. It did acknowledge that Maintenance mode is on but apart from that still won't boot from Floppy. Any assistance is much appreciated. Thanks
2 REPLIES
Terry Hutchings
Honored Contributor
Solution

Re: Proliant 800- Deleted Sys partition-Still

Have you tried a different floppy drive? I would not recommend running the system configuration utility with "maintenance mode" on, since nothing done in there will be saved with that switch on.
The truth is out there, but I forgot the URL..
Tudor Moore
Occasional Contributor

Re: Proliant 800- Deleted Sys partition-Still

The smallest thing-Changed floppy drive-boots fine. Thanks V. Much.