HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant ml370

 
Lukas_7
Occasional Advisor

Proliant ml370

Hi friends,

I have ml370 G2 with win2k. When server boot message "scsi bios not installed" appears. I read that this message is not problem, but I have to change LUN support setting in SCSIselect utility (ctrl +A) and I can`t open this utility. Could you help me please with this issue?

Lukas
8 REPLIES
Stf
Esteemed Contributor
Lukas_7
Occasional Advisor

Re: Proliant ml370

ROMpaq update was not helpfully ;o(. Is there some another tips or recommendations?

Thanks Stf

Lukas
Stf
Esteemed Contributor

Re: Proliant ml370

Do you have the ref of your scsi controller?

Stf ;-)
Lukas_7
Occasional Advisor

Re: Proliant ml370

There are 2x Compaq 64-Bit/66MHz Dual Chanel Wide Ultra SCI Adapter and Smart Array 532Controler.

Lukas
Stf
Esteemed Contributor

Re: Proliant ml370

Lukas_7
Occasional Advisor

Re: Proliant ml370

This update I`ve already applied ;o(.

Lukas
Brian_Murdoch
Honored Contributor

Re: Proliant ml370

Hi Lukas,

Compaq/HP use their own modified Adaptec BIOS in the embedded SCSI adapters so the CTRL-A option is not available in many systems.

If you do not have any SCSI devices attached to the embedded SCSI controllers you can simply disable them in the Rom Based Setup Utility (RBSU).

Press F9 when prompted at bootup and select the PCI devices from the menu.

You can enable and disable the embedded controllers by selecting them and pressing enter. A choice will appear on the screen.

I have attached an image showing the PCI section of the RBSU menu for clarity.

If you can live with the message I would not make any changes but you can get rid of it as descibed above if required. Obviously if you have other devices attached to the embedded SCSI ports then DO NOT disable them.

I hope this helps.

Brian
Lukas_7
Occasional Advisor

Re: Proliant ml370

Thanks Brian,

your answer help with message appearing.

But still I can`t edit SCSI select utility for enable LUN support ;o(.

Do you know, where can I enable LUN support?

Lukas