HPE Community
ProLiant Servers - Netservers
1754071 Members
3344 Online
108811 Solutions
New Discussion юеВ

Re: Replaced system board now All drives failing.

 
Jason Behring
New Member

тАО11-13-2007 08:19 AM

тАО11-13-2007 08:19 AM

Replaced system board now All drives failing.

I just had to replace the system board in a DL380 G3. Now when I boot the orginal problem (no video) is corrected, but all my drives are showing as failing. Even if I put a new drive in.
0 Kudos
Reply
2 REPLIES 2
Iain McCracken
Frequent Advisor

тАО11-14-2007 12:09 AM

тАО11-14-2007 12:09 AM

Re: Replaced system board now All drives failing.

Did you remember to swap over the raid controler it is on a little board called a ROC raid on a chip If you boot of smart start cd and run diagnistics test array controller if you havent swapped the ROC over it will say no controller detected
0 Kudos
Reply
Jason Behring
New Member

тАО11-27-2007 05:57 AM

тАО11-27-2007 05:57 AM

Re: Replaced system board now All drives failing.

The only module I see that I see that I can removed is the SCSI RAM. I can get into the SCSI Array configuration, but it is telling drives that I were all good before I replaced the system board are now failed.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.