Servers - General

UPS Management Module, lost functionality after firmware update

 
Rusty04
New Member

UPS Management Module, lost functionality after firmware update

After updating firmware to 2.1.11 on an AF401A UPS Management Module, I can no longer add or edit currently attached devices nor can I control any of the load segments (power on/off/cycle) via the HTTP web interface.  I can connect to the management module via the web interface & it shows the correct parameters for the UPS (mains & battery voltages, load etc),

 

I can add/edit & control devices attached to the UPS by telnet & via the configuration port with Hyperterm.  I have done a “Restore Configuration to Manufacturer Settings” after updating firmware.

 

Hardware information

Management Module

  Firmware  Value

  ------------   --------

  Net+OS:   7.2

  Application:  2.1.11

  HTTP: 4.04 PBuilder

  BSP:   1.4.2

  Bootloader:  1.4.2

  Compiler:  3.4 (gcc)

 

UPS:

Model: T1000XR

Version: 2.03

 

Is there anything else I can do to restore full functionality to the card?

 

Thanks

Ian