Community
Switches, Hubs, and Modems
cancel
turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

ACLs by range of IP rather than network

Topic Options
Jon Ferrara
Jon Ferrara
Occasional Contributor

‎05-29-2007 05:12 AM

‎05-29-2007 05:12 AM

ACLs by range of IP rather than network

Forgive the duplicate post.. I forgot some pertinent info.

Procurve 5412
FW k.12.02


I am in the preliminary stages of setting up a NAC (Network access control) solution. My goal is to set up multiple DHCP scopes (Authorized, restricted, and quarantined) based on authentication.

My question is, can I set up ACLs based upon a range of IP addresses or must they be setup by network (ie create additional networks on my lan, and issues DHCP to each network). I would like to keep my routing config as is and just use 3 ranges in my existing subnet. Any help or direction is much appreciated.

Jon
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.