Community
Switches, Hubs, and Modems
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

VLAN Configuration

 
smjones45832
smjones45832
Occasional Visitor

‎09-12-2011 08:37 AM

‎09-12-2011 08:37 AM

VLAN Configuration

Facility with one 5412 Chassis switch and 11 Procurve 2510-48 switches.  All 11 of the 2510's are connected to switch A (24 port) in the 5412 chassis.

 

Have 15 Cisco wireless access points that are currently only setup for private access.  Need to set these up for public access.  Want to configure a public_access vlan on the switches so that I can pass traffic both public and private, but not exactly sure how to go about it or where to start.

 

Any advice would be appreciated.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.