apply config CLI script that uses wizard (snmpv3)

[swaize]

I am currently trying to roll out SNMPv3 across a number of siwtches via PCM.

When you run commnad :
enable snmpv3

This initaites an SNMPv3 config wizard.

Normally when you use a CLI script - you put each command on a new line and it executes each in turn however, because the wizard is invoked, this seems not to work

Is there any syntax I can use in the command file that will enable it to input options into the wizard as required?

[Matt Hobbs · Accepted solution]

You could use the Communication Parameters in Device feature to enable SNMPv3 on multiple switches at once. Select all the switches you want to enable it on, use that feature and follow the wizard.