Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

error with trafficd, traffic monitor is blind

LADROUZ_1
Occasional Contributor

error with trafficd, traffic monitor is blind

Hi ,
Since my upgrade to Procurve Manager+ 1.6 ,Ms visual C++ debugger repport constantly an error on line 980 in trafficd .
The discovery process run well but traffic monitor do not show stat on the ports managed (5308xl's).
Any one idear on this prob ?
Second ,
How can i exploit PCM+ to manage QOS and TOS in my network (5308xl switchs) , is there a howto ?
Best to all .

3 REPLIES
Hector Manzo
Frequent Advisor

Re: error with trafficd, traffic monitor is blind

Hi,

I don't know if you have already tried installing the latest patches found on the software HP web site : http://www.hp.com/rnd/software/network_management.htm

Try installing Patch A and if you wish also install the find node patch. If you still see the problem send me a snapshot of where you see the error messages.
I'm assuming the error message are displayed in the event log in PCM?

You don't see stats from 5308 switches. You probably have already done so, but have you added the device and the individual ports to traffic monitor? How do you identify that no data is being collected? Are you collecting stats or sflow data?

Could you be more specific on what you would like to try to accomplish with PCM as far as QOS and TOS?
LADROUZ_1
Occasional Contributor

Re: error with trafficd, traffic monitor is blind

Bonjour ,
For patch and find node ,this is done .
i send you by attachement a screen of the error .
I already add switch ports to traffic monitor , ports represent link between backbone switch (data flow is hight , get info using CLI on switch).
Thank .
Hector Manzo
Frequent Advisor

Re: error with trafficd, traffic monitor is blind

What's the frequency of this error?
Have you noticed if it's trigged by a specific event?

The error you see indicates a bad memory pointer.