Invalid replication synchronization alarm does not go away

[ali_mir]

Hello Everyone,

I have 2 old arrays which used to be replication partner. After I removed the volume collection under each array I paused them and then deleted those replication partners from both side (on both arrays)

But still both of them are alarming for issue with synchronizing replication! I can not make them go away.

These arrays are old and out of warranty, I just want them to be quiet for another 2 months

Thanks,

Ali

[support_s]

System recommended content:

1. Error - WARNING :: Replication System is Accumulating a Large Number of rows that have not been Transmitted to Node(s)

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.

[Mahesh202 · Accepted solution]

Hi Ali

1. You can retrieve the alarm ID by running the following command:
   • alarm --list
2. Delete the alarm:
   • alarm --delete <alarm_id>
   • For NOS 5.0.5.200 and above, you may delete alarms from WebUI.

The alarms can be deleted or modified from the CLI manually to stop emailing daily. Once deleted, you should no longer receive emails for the alarms.

Hope this helps.

Regards
Mahesh