HPE Community
Array Performance and Data Protection
1751946 Members
4791 Online
108783 Solutions
New Discussion

Startup encryption

 
SOLVED
Go to solution
tshipp118
Occasional Contributor

‎09-27-2017 11:12 AM

‎09-27-2017 11:12 AM

Startup encryption

Hello,

I am setting up an array and encryption is a requirement. For the startup mode in Secure, do this mean the UI comes up fully and is manageable and you just have to put in the passphrase to access the volumes, or on startup, you have to put in the passphrase?

Labels:
0 Kudos
Reply
1 REPLY 1
jharris-itguy16
Advisor

‎09-28-2017 02:51 PM

‎09-28-2017 02:51 PM

Solution

Re: Startup encryption

When the array starts up in secure mode you will need to log into the UI (GUI or CLI) and enter your passphrase before it will start allowing FC or ISCSI connections to the volumes.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.