HPE Community
Array Setup and Networking
1819682 Members
3576 Online
109605 Solutions
New Discussion юеВ

Does anyone know how to delete/clear an "alarm"? I see acknowledge/unacknowledge and change reminder. But no 'delete' or similar...

 
pbitpro96
Advisor

тАО10-19-2017 10:04 AM

тАО10-19-2017 10:04 AM

Does anyone know how to delete/clear an "alarm"? I see acknowledge/unacknowledge and change reminder. But no 'delete' or similar...

NimbleOS 4.2.0

Events-Alarms

An alert triggered, I made the change to clear it after acknowledging it. Now I get reminded every day of that alert - and I can't seem to get rid it of it!

1 person had this problem.
Labels:
0 Kudos
Reply
2 REPLIES 2
pbitpro96
Advisor

тАО10-20-2017 10:40 AM

тАО10-20-2017 10:40 AM

Re: Does anyone know how to delete/clear an "alarm"? I see acknowledge/unacknowledge and change reminder. But no 'delete' or similar...

So you cannot delete alarms form the GUI!

log on via putty/CLI and run 'alarms --list'

Get the ID of the alarms to be cleared and then run 'alarms --delete ID' like 'alarms --delete 1'

Reply
JoeStern
New Member

тАО03-06-2018 06:22 AM

тАО03-06-2018 06:22 AM

Re: Does anyone know how to delete/clear an "alarm"? I see acknowledge/unacknowledge and

Thanks for that -- I'm finally free of that pesky reminder. 

I found that the actual command was alarm not alarms (singular is correct, not plural). 

Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.