HPE Community
BladeSystem - General
1847794 Members
2693 Online
104021 Solutions
New Discussion

Active/Active configuration

 
KhalidRasool
Occasional Contributor

‎10-02-2016 07:43 PM

‎10-02-2016 07:43 PM

Active/Active configuration

Hi Everyone,

One of our site we are using flex-10/10D virtual connect module having the firmware of 4.40. Six blades 460 Gen 9 and using Flex fabric 20Gb 2 port 650 FLB adapter. Is there any possibility to configure redundancy at VC level with Active/Active scenario. We don't want any sort of teaming or bonding at OS level. Several time we tried to configure redundancy at VC level in between Bay 1 and Bay 2 ports but always getting Active/SBY configuration.

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.