HPE Community
BladeSystem - General
1753717 Members
4961 Online
108799 Solutions
New Discussion

Bl890c i2 root disk sync process is very slow

 
Jack007
Frequent Advisor

‎12-17-2011 08:56 AM

‎12-17-2011 08:56 AM

Bl890c i2 root disk sync process is very slow

After I replace one of the two root disks (they consist a 1+0 raid group) , the sync starts automatically.

But the  process is very slow. It just goes 3.xx% after about 48 hours.

 

And the rebuild priority has been set to high by the command:  saconfig /dev/cissX -r high. 

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎12-18-2011 09:53 PM

‎12-18-2011 09:53 PM

Re: Bl890c i2 root disk sync process is very slow

Whenever I did this the sync took up to 24 hours for a 300GB disk - seems to be normal.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Jack007
Frequent Advisor

‎12-18-2011 11:53 PM

‎12-18-2011 11:53 PM

Re: Bl890c i2 root disk sync process is very slow

24 hours is acceptable.

 

But my issue is 3.xx% took 48 hours and more.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.