ebipa ip address

[geolek]

Hello,

after ebipa first setup (C7000) i have tried to change initial enclosure bay ip addresses but without success.

Do i have to follow i specific procedure - i cannot find any.

[Raghuarch]

Hi Geolek,

There is no specific procedure to change the EBIPA. You can type in the IP in EBIPA page and Enable EBIPA and Click on Apply.

Syslog should give a message that the EBIPA IP address is modified to the New IP.

If the IP is not applied you should get a error in Syslog. r u getting any error?

Regards,
Raghuarch

[Adrian Clint]

Are the ILOs on the blades themselves set to static or DHCP?

They must be set to DHCP for EBIPA to work.

If they are not, set them all to DHCP then reconfigure EBIPA and watch the IP addresses change when they are reset.

[James ~ Happy Dude]

Hello,

Refer:
h20000.www2.hp.com/bc/docs/support/SupportManual/c00705292/c00705292.pdf
Page 77 onwards,

James.

[geolek]

i changed ebipa ips from static to dhcp, after chassis and switch reset went back to static ebipa ips and the problem solved.

Thanxs

[ross stewart_2]

I have I think a similar problem. Question is how do i change the setting to dhcp when I can't remote on through the blades ilo port ie need to do this remotely